Yamaha R15 v2 (FULLBODY) decal sticker / Wrap
Scratch-resistant laminate
100% Waterproof
Durable for up to 3 years
Full HD quality
Brand - 3m Original
Does not leave marks if removed and does not damage your motorbike body.
NOTE:
- Lamination can request DOFF (Matte) or Glossy
- Type: Full Body NON Cutting
FULLBODY NON cutting is only printed in segments according to the body of the motorbike, it just hasn't been cut by the engine. but because the body of the motorbike has curves,
everything definitely needs to be adjusted by the installer, and the non-cutting full body is much liked by the sticker fixers more freely.
- In the packing, there is already a install plan according to the parts of the motor body and a tutorial on how to install it.
Application Instructions
1.Take out the decals carefully from the container.
2.Place the decals on table before applying and check the left and right side properly. Ensure sticker is in appropriate position without any bubbles and overlapping also count number of pieces.
3.Clean the surface of your vehicle with distilled water (please do not use ground or any hard water) to make it free of all dust & grease and wipe with a clean dry cloth.
4.Remove the paper from bottom of decals. Make sure you remove this gently.
5.Moist the decals with water from back side & paste it on the desired location.
6.When you are satisfied with the placement, apply the decals on surface with the help of squeeze and water.
7.Set the decals on the surface and once you are satisfied with the placement, apply the decals on surface of car.
8.Gently remove the protection tape. Make sure the decal does not get stretched.
Important Instructions
1. Professional installation is highly recommended for this product.
2.If there is moisture in air than heat air dryer is recommended on surface of vehicle (not on decals) to remove excess water from surface.
3.It is recommended to apply decals in Sunlight. This will make application easier.
4.Wipe with isopropyl alcohol or other residue-free cleaner. Do not use toluene it may spoil metallic paint top coat.
6.Dry the surface with clean, lint-free cloth before the cleaning solvent evaporates.
7. Do not wash your vehicle for minimum 25 hrs after pasting.
Please follow instructions UKS mods is not responsilbe for glue damage while application .